![]() We are just trying to run below command to get tx power to increase. They are also un-sure to relate tx power relation to antenna. Resources: irq:212 memory:18000000-180fffff memory:18200000-1820ffff memory:18100000-181fffffĬapabilities: pm msi pciexpress msix bus_master cap_list ethernet physical wirelessĬonfiguration: broadcast=yes driver=iwlwifi driverversion=5.4.24-iot-gate-imx8-2.4 firmware=50.3e391d3e.0 ip=x.x.x.x latency=0 link=yes multicast=yes wireless=IEEE 802.11 ![]() Qsz-byt qsz-pkt flows drops marks overlmt hashcol tx-bytes tx-packetsįilename: /lib/modules/5.4.24-iot-gate-imx8-2.4/kernel/drivers/net/wireless/intel/iwlwifi/iwlwifi.koĪuthor: Copyright(c) 2003- 2015 Intel Corporation ĭescription: Intel(R) Wireless WiFi driver for lshwĬapabilities: pci pm msi pciexpress bus_master cap_list rom rw-r-r- 1 root root 1101228 iw wlan0 infoĬhannel 1 (2412 MHz), width: 20 MHz, center1: 2412 MHz For desktops: Towards the center of the window under Computer sleep and Display sleep sliders, check the Wake for Network access box. Is there any firmware that allows increasing the tx ls -l /lib/firmware/iwlwifi-cc-a0-* The correct answer to whether you should change the WiFi AP transmit power depends on the network density and the amount of interference. (OpenWrt automatically set the levels properly if you select the right nation in the wifi settings.) But here are additional reasons that you should consider. Increasing transmit power over the the limits for your country is against the law. Wifi interface runs as AP mode on 2.4G band. Exceeding transmit power limits TL DR Don't do it. It can only be deceased below default value. However it seems firmware/driver is not allowing it to be increase above 22 dBm. We are looking to increase AX200 tx power to 30 dBm (from default 22 dBm).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |